久久久久亚洲AV成人无码-国产美女久久精品香蕉69-国产综合久久久久久鬼色-久久这里只有精品18-亚洲女久久久噜噜噜熟女,亚洲精品色婷婷在线影院,亚洲一区在线二区,天堂中文在线资源库用,国产内谢xxxxxxxhd,亚洲中文字幕在线精品 ,国产一区 国产精品 精品三_国产精品一区二区久久宅男_国产亚洲美女精品2020久久久_91精品国产自产在线观看永久 ,久久久精品成人免费观看国产下-91精品人妻一区二区三区蜜桃-亚洲午夜精品专区国产-国产福利一区二区三区高清

行業新聞

當前位置:首頁 > 新聞中心 > 行業新聞

干燥機的出口露點不合格的原因?

來源:http://556rte.cn/   日期:2020-10-21   瀏覽量:0
TAG:山東制氮機,山東干燥機,山東螺桿鼓風機,山東空壓機,山東自動排水器

壓縮空氣的含水量多少一般用壓力露點來表示,露點越低,表示含水值越小,干燥機的干燥效果越好。在工業中,由于各種用氣設備及工藝流程的不同,需要有不同壓力露點的壓縮空氣干燥設備為用戶提供選擇的可能。有的要求壓力露點達到-20℃,有的要求壓力露點不低于-40℃,還有的壓力露點要求在-70℃左右。

The moisture content of compressed air is generally expressed by the pressure dew point. The lower the dew point is, the smaller the water content is, the better the drying effect of the dryer is. In industry, due to the different gas equipment and process flow, compressed air drying equipment with different pressure dew point is needed to provide users with the possibility of selection. Some require the pressure dew point to reach - 20 ℃, some require the pressure dew point not less than - 40 ℃, and some require the pressure dew point to be about - 70 ℃.

干燥機出口露點不合格的原因:

Reasons for unqualified dew point at dryer outlet:

1、干燥機出口露點過高

1. Dryer outlet dew point too high

2、超出最大流量值和超過設計條件,在配置吸附式干燥機時應根據空壓機排氣量和工作流量設計。

33887d3c9d53e790d0c14ae9384e144.jpg

2. If the maximum flow and design conditions are exceeded, the design of adsorption dryer should be based on the air compressor discharge and working flow.

3、干燥劑沒有吸附效果,需更換濾芯

3. The desiccant has no adsorption effect, so the filter element should be replaced

4、氣流進入干燥機前沒有預處理除去液態水,壓縮空氣進入干燥機前應進行液態水預處理,否則超過吸附劑的吸附能力,吸附劑飽和后將失去吸附效果。

4. There is no pretreatment to remove liquid water before the air flow enters the dryer. Liquid water pretreatment should be carried out before the compressed air enters the dryer. Otherwise, if the adsorption capacity of the adsorbent is exceeded, the adsorption effect will be lost after the adsorbent is saturated.

5、干燥機使用壽命已結束

5. The service life of dryer is over

壓縮空氣干燥機(干燥機|吸干機)是壓縮空氣系統的重要組成部分,常見的壓縮空氣干燥機有冷凍式干燥機和吸附式干燥機。貝騰模芯干燥機是兩者的升級版,能徹底解決壓縮空氣含水問題,幫助企業提高壓縮空氣品質,從而提高生產工藝,降低生產成本。

Compressed air dryer (dryer | suction dryer) is an important part of compressed air system. The common compressed air dryers include freeze dryer and adsorption dryer. Beiteng core dryer is an upgraded version of the two, which can completely solve the problem of water content in compressed air, help enterprises improve the quality of compressed air, so as to improve the production process and reduce the production cost.


上一篇:制氮機設備的安裝對場地的具體要求
下一篇:山東制氮機常見的故障處理方式

福贡县| 商城县| 旌德县| 清镇市| 望城县| 乌什县| 双流县| 白山市| 合山市| 白朗县| 河曲县| 桦川县| 菏泽市| 江津市| 保康县| 托克托县| 顺昌县| 淮南市| 德保县| 西平县| 栾川县| 石棉县| 婺源县| 青龙| 买车| 三穗县| 罗定市| 龙门县| 仙游县| 柳河县| 乌海市| 徐闻县| 乌拉特中旗| 汕头市| 兴仁县| 绍兴县| 甘德县| 张家港市| 平江县| 神农架林区| 金昌市|